Drives bearing races, bushings, and seals in straight and square with 39 billet adapters and four handles, covering 10-81mm and SAE sizes for axle and transmission bench work.
A 43-piece bearing race and seal driver set for installing races, seals, and bushings without cocking them or peening the sealing face. It ships with 39 machined adapters and four handle shafts, so instead of tapping a race in with a punch and a prayer you seat it flat with a driver that actually matches its outside diameter.
The metric adapters run from roughly 10-12mm up through 81mm and the SAE adapters cover 3/8 inch up to 1-3/16 inch, which spans the straight races and lip seals you hit on a transmission bench: tailshaft and extension housing bushings, pump and stator bushings, and the extension housing output seal, along with front wheel bearing races and axle seals on the same job. You pick the adapter that rides on the outer edge of the race, thread on a handle, and drive it home square so it does not tip and gouge the bore.
Bodies are turned from billet aluminum so they take repeated hammer blows and shrug off solvent and gear oil. Set weight is about 6.3 pounds. Manufacturer part number SL-43PC.
Ships from the USA, handling in 1-2 business days.
| Type | Bearing race, seal, and bushing driver set |
| Pieces | 43-piece (39 driver adapters, 4 handles) |
| Metric range | 10-12mm through 81mm |
| SAE range | 3/8 in through 1-3/16 in |
| Material | Billet aluminum |
| Set weight | 6.3 lb |
| Part number | SL-43PC |
| Ships | From the USA |
