Dodge Dakota Front Driveshaft 938-014 for 4WD 2001-2007

This is a complete front driveshaft assembly that replaces Mopar 52105982AC and cross-references to Dorman 938-014 and 65-9151. It runs from the front output of the transfer case to the front differential.

Listed fitment: 2001-2007 Dodge Dakota 4WD with either the automatic or manual transmission, 2001-2003 Dodge Durango 4WD and AWD with the automatic, and 2006-2007 Mitsubishi Raider 4WD with the automatic or manual. The 2004-up Durango uses a different front shaft, so check the number on your old one or run the VIN before ordering.

The shaft is steel with a protective coating, dynamically balanced, and the slip section comes greased. A torn joint boot, a clunk when you engage 4WD, or a vibration that only shows up in 4-high are the usual signs the shaft is worn out.

Install: mark the flanges so the new shaft goes in with the same clocking, unbolt the front differential end and then the transfer case end, and bolt in the new shaft. Torque the flange bolts to factory spec and road test in 2WD and 4-high.