Replaces all four worn front engine, torque strut, and transmission mounts on a 2012-2014 Honda CR-V 2.4L to kill engine clunk and shake.
This is the full front mount set for a 2012-2014 Honda CR-V with the 2.4L four-cylinder and automatic transaxle: front engine mount, front upper torque strut mount, front lower torque strut mount, and the left transmission mount. On these CR-Vs the rubber in the factory mounts breaks down by 100-150k miles and lets the engine/trans assembly rock under torque - you feel it as a clunk on takeoff and shifting, a shudder at idle in gear, or extra vibration coming through the floor and steering wheel.
Replacing all four at once is the right call rather than chasing one bad mount at a time, since a worn mount shifts load onto the others and speeds up their failure too. Cross-reference part numbers on this kit: JFBAJCWEM00438K4, A65055, A65052, A65070, A65069, 9815, 9796, 9798, 9802, EM-7073, EM-5954, EM-7055, EM-7111 - check these against your CR-V's existing mounts before ordering if you're only replacing a subset.
Install is straightforward with the engine supported from above or below while each mount is swapped one at a time so the powertrain never loses support. Comes with a 1-year manufacturer warranty.
| Brand | JC Whitney |
| Fits | Honda CR-V 2012-2014, 2.4L L4, Automatic Transmission |
| Kit contents | Front engine mount, front upper torque strut mount, front lower torque strut mount, left transmission mount |
| Reference part numbers | JFBAJCWEM00438K4, A65055, A65052, A65070, A65069, 9815, 9796, 9798, 9802, EM-7073, EM-5954, EM-7055, EM-7111 |
| Weight | 8.55 lb |
| Condition | New |
| Warranty | 1-year |
