4WD transfer case actuator motor for the 2014-2021 Jeep Cherokee KL and Chrysler 200 AWD. Replaces Mopar 68227808AB and Dorman 600-223.
This is the 4WD actuator motor for the 2014-2021 Jeep Cherokee KL and the all-wheel-drive Chrysler 200. It replaces Mopar 68227808AB and crosses to Dorman 600-223. It has a round 2-blade connector and a 4-hole mounting flange. No wiring harness comes with it, so it plugs into your existing connector.
These vehicles use a disconnecting 4WD system that shuts off the rear driveline to save fuel and brings it back in when needed. If this motor fails, the dash shows a Service 4WD System message and the vehicle can stay in front-drive only.
Scan for 4WD module codes before you replace parts, and check the connector for water intrusion and corroded pins. Clean the mounting face before you install the new motor, then clear the codes and test drive so the system can cycle.
| Fits | Jeep Cherokee KL 2014-2021, Chrysler 200 AWD |
| Replaces | Mopar 68227808AB, Dorman 600-223 |
| Connector | 2-blade, round |
| Mounting holes | 4 |
| Harness | Not included, plugs into the factory connector |
