Transfer Case Shift Cable for Jeep Wrangler JK 2007-2011

This is the Dorman 905-620 transfer case shift cable for the 2007-2011 Jeep Wrangler JK. It crosses to Mopar part numbers 52060462AD, 52060462AE, 52060462AF and 52060462AG, and it matches the original cable length and end fittings so the lever travel stays correct.

On the JK the transfer case is cable-shifted, not electric, so every range change runs through this one part. When the cable stretches or the housing fills with grit and water, the lever gets vague and heavy, 4LO becomes hard to reach, and eventually the lever moves through its arc while the case stays in whatever range it was in. If the cable end snaps at the transfer case, the lever goes completely dead.

Before you buy a cable, get under the Jeep and watch the shift lever on the case while someone works the lever inside. If the case arm is not moving through its full travel, the cable is the problem; if the arm moves fully and the case still will not change range, the fault is inside the case. When you install the new one, pop the retainer at the transfer case bracket, seat the grommet in the floor correctly so water does not run down the housing, and adjust the cable at the shifter end so the detents line up in all four positions before you drive it.