Bends 3/16, 1/4, 5/16, and 3/8 inch line clean without kinking, so cooler and brake lines drop right into place.
When a transmission cooler line or a rusted brake line has to come out and get replaced, the hard part is putting the new bends back in without crimping the tube shut. A cheap spring bender flattens soft line and a knee across the bumper never gets the angle right. These OEMTOOLS bending pliers give you controlled left, right, and offset bends up to 90 degrees so a fresh line follows the same path as the one you pulled off.
The plier body is forged alloy steel with knife-edge separators that grip the tube and keep the wall from collapsing as it wraps the die. Two dual-sized adapters cover 3/16, 1/4, 5/16, and 3/8 inch line, which is the range you run into on transmission cooler lines, fuel lines, and hydraulic brake tube in copper, brass, aluminum, or soft steel. It works in tight spots on the vehicle where a bench bender will not reach. Ships from the USA.
| Tube sizes | 3/16, 1/4, 5/16, 3/8 in |
| Bend range | Left, right, offset up to 90 degrees |
| Material | Forged alloy steel, knife-edge separators |
| Adapters | Two dual-sized adapters included |
| Line types | Copper, brass, aluminum, soft steel |
| Ships from | USA |
