Ten-piece race and seal driver set that seats bearing races and seals square without gouging the bore.
Anybody who has driven a bearing race or a seal in with a punch and a hammer knows how that ends: a cocked race, a nicked bore, or a seal that leaks the day after you close it up. This 10-piece driver set fixes the guesswork. It gives you a solid handle and nine dual-sided adapters, so instead of tapping on the edge of a race you push on a collar that matches its diameter and drive it in flat and square the first time.
The driver collars are turned from aluminum alloy with a corrosion-resistant coating, and each one is laser marked with its size so you are not squinting to find the right disc mid-job. The nine double-ended adapters cover the common race and seal sizes you run into on axle shafts, wheel bearings, transmission tail housings, and pinion seals, which makes this a set that stays on the bench rather than one you buy for a single repair.
Everything drops into a blow-molded case so the discs do not wander off into the bottom of a toolbox. A practical, do-it-right driver set for anyone seating races and seals on a regular basis. Ships from the USA.
| Pieces | 10 (1 handle, 9 dual-sided adapters) |
| Material | Aluminum alloy, corrosion-resistant coating |
| Marking | Laser-engraved size on each collar |
| Use for | Bearing races, wheel seals, pinion & tail-housing seals |
| Storage | Blow-molded carry case |
| Ships from | USA |
