Range Rover Velar L560 Transfer Case Mount LR105925

A replacement transfer case mount for the Land Rover Range Rover Velar (L560 platform). It replaces Land Rover part number LR105925 and is built from a molded rubber isolator bonded to an aluminum bracket, the same layout as the factory piece.

The transfer case mount carries the weight and torque reaction of the transfer case behind the transmission. When the rubber cracks or separates from the bracket, the case moves under throttle and on shifts. The usual complaints are a clunk when pulling into drive or reverse, a thump on take-off, and a drone or vibration through the floor at cruise. A collapsed mount also changes driveshaft angle, which can wear the prop shaft joints faster.

On the job: support the transmission and transfer case with a jack before unbolting the old mount. Compare the new mount against the old one on the bench before installing, set the driveline at its normal ride position, then torque the fasteners to the factory spec. Check the prop shaft joints and the transmission mount while you are under there, since a failed transfer case mount often loads them.