52pc Bushing & Seal Driver Set with 14pc Bearing Puller

This is a two-in-one bench set for anyone rebuilding transmissions, transfer cases and axles: a 52-piece bushing and seal driver kit paired with a 14-piece bearing separator and puller. The driver side has 49 stepped disc sleeves plus a thick knurled handle, so you can pick a disc that matches the outer race or bushing OD and drive it in dead square instead of walking it in with a socket and a hammer. The puller side adds jawed bearing separators and pilot jaws for grabbing pressed-on bearings and pulling them off shafts.

Use the driver discs to seat pump bushings, extension-housing bushings and case bushings, and to install axle and output seals to the correct depth without cocking or tearing the seal lip. The separator clamps behind a bearing so you can press or pull it off a shaft or carrier without marring the journal. Between the two, most of the bearing, bushing and seal work on a valve body, case half, transfer case or differential is covered by one box.

The discs and handle are hardened steel with an oxide black finish, and the disc edges are polished so they seat against a race or seal without gouging it. Everything stores in a blow-molded case that keeps the sizes sorted on the bench. Ships from the USA; in-stock items ship same day.